Wheel Bucket Spiral Washing Machine Sand Washer For River Sand Cleaning XSD2610

Wheel Bucket Spiral Washing Machine Sand Washer For River Sand Cleaning XSD2610

Wheel Bucket Sand Washing Machine Introduction:

The Wheel Bucket sand washing machine adopts advanced technology, and the wheel bucket sand washing machine combines the high-efficiency sand washing equipment developed by the domestic sandstone industry. The wheel bucket sand washing machine has high washing efficiency, reasonable structure and large output, and the sand loss is small during the sand washing process of the sand washing machine. In particular, its transmission parts are isolated from water and sand, so the failure rate is much lower than that of the current common sand washing machine. The wheel bucket sand washing machine is the best choice for upgrading the domestic sand washing industry.

Wheel Bucket Sand Washer Main Applications:

Wheel Bucket Sand Washer is widely used in the washing of materials in sand and gravel, mining, building materials, transportation, chemical, water conservancy and hydropower, concrete mixing stations and other industries.

White Lai Wheel Bucket Sand Washer Machine Models:

Wheel Bucket Sand Washing Machine Malfunction Repair Instructions:

Sand washing machine often affects production due to motor failure during use. The main failure phenomena are:

Core troubleshooting:

The stator and rotor are the magnetic circuit portions of the motor and are usually laminated with silicon steel sheets insulated from each other. The rotor core is easily damaged and deformed for the following reasons:

1. If the bearing wears excessively or the assembly is not good, the stator and the rotor will rub and damage the surface of the iron core, which will cause short circuit between the silicon steel sheets, increase the iron loss of the motor, and the motor temperature is too high. At this time, use a tool such as fine boring to remove the burr, eliminate the short-circuit of the silicon steel sheet, clean it, apply the insulating varnish, and heat and dry.

2. The surface of the core is corroded by moisture. At this time, it can be sanded and then coated with insulating varnish.

3. High heat is generated around the group to burn the core or the tooth. The deposit can be removed with a chisel or scraper and coated with insulating varnish for drying.

4. When the old winding is removed with too much force, the thief is skewed and flared outward. At this time, it can be trimmed with tools such as needle-nosed pliers and wooden hammers to reset it, and hard insulating materials such as green paper and rubber wood are added between the gap-free silicon steel sheets which are not handled well.

5. The iron core and the base are loose, and the original set screw can be tightened. If it fails, re-drill the locating hole on the base and tap the wire to tighten the set screw.

Our Wheel Bucket Sand Washing Machine Sand Washer for River Sand Cleaning at Customer Sites:

sand washing equipment

spiral sand washer

Wheel Bucket Spiral Washing Machine Sand Washer For River Sand Cleaning XSD2610 Images